[AT] tractor electrical question

Jason dejoodster at gmail.com
Thu Aug 26 06:08:46 PDT 2021


The coil you should have gotten sb 396547r93. Which is a 12v internal
resistor coil.

It's unlikely if you have the right coil, that both old and new are bad.

Which leads to condenser, wiring, or ignition switch

Jason

On Wed, Aug 25, 2021, 11:00 PM John Hall <jtchall at nc.rr.com> wrote:

> There is a wire tied in from the starter solenoid also. You would assume a
> new OEM coil to be good but who knows. All I know is it acts the same with
> both coils. I will note that the new coil had to be rotated 180 in the
> bracket to get it to hook up. The power is going in the plus side, just
> like schematic shows. Maybe they just put it in wrong at factory?
>
> John
>
> On 8/25/2021 11:52 PM, Jason wrote:
>
> Generally most coils have a resistor before them to lower the voltage so
> they don't burn up the points. Some applications have a booster wire from
> the small  terminal on the starter solenoid. Since there is a voltage drop
> when cranking, this booster wire temporarily raises the voltage to help
> during starting.
>
> If everything else is fine. A coil that fails as it warms up is a coil
> getting close, to well, failing.
>
> Jason
>
> On Wed, Aug 25, 2021, 10:22 PM Howard Pletcher <hrpletch at gmail.com> wrote:
>
>> Is that the original coil?
>>
>> I'm not familiar with the 454, but in the truck world, most coils are
>> intended for 6V use.  There is a resistor wire in the harness that drops
>> the voltage while the current is flowing with the points closed.  But there
>> are also coils intended for 12V use with no resistor wire.  If that is not
>> the original coil, perhaps you have the wrong one.
>>
>> Since it seems to work fine with 12V applied, I'd probably run another
>> wire from the ignition switch to the coil to bypass any possible resistor
>> wire.
>>
>> Howard
>>
>> On Wed, Aug 25, 2021 at 11:08 PM John Hall <jtchall at nc.rr.com> wrote:
>>
>>>
>>> If there is, I can't find it. Closes thing I have found is the
>>> diode/rectifier for the alternator. Its inline and is tied in on this
>>> particular "circuit" . Matter of fact, the side opposite the alternator
>>> is where the fuel solenoid feeds from.
>>>
>>> John Hall
>>>
>>>
>>> On 8/25/2021 11:05 PM, Spencer Yost wrote:
>>> > Maybe there’s an external resistor?
>>> >
>>> > Spencer
>>> >
>>> > Sent from my iPhone
>>> >
>>> >> On Aug 25, 2021, at 10:35 PM, John Hall <jtchall at nc.rr.com> wrote:
>>> >>
>>> >> Got what I hope is a simple question. On my IH 454 tractor, is the
>>> voltage going to the coil a constant 12V? I'm having some issues with it
>>> running bad when it gets hot (I've already replaced everything but the plug
>>> wires). Found out today that if I run a jumper wire from battery to the
>>> coil, the problem goes away. Take it off problem comes back, put it back it
>>> goes away, take it off, it comes back. So I am tracing the wiring but this
>>> one isn't simple, new enough there are tons of gauges, fuel solenoids,
>>> safety switches, etc. Anyway, if I check voltage at the coil, the fuel
>>> solenoid, and there is one small terminal on starter solenoid that all read
>>> 12V if the switch is on. If I bump the engine over slightly (I guess the
>>> pts are closing) then the coil and starter drop to just under 6V, fuel
>>> solenoid stays the same. So shouldn't there always be 12V at the coil?
>>> >>
>>> >> John Hall
>>> >> _______________________________________________
>>> >> AT mailing list
>>> >> AT at lists.antique-tractor.com
>>> >> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>>> >>
>>> > _______________________________________________
>>> > AT mailing list
>>> > AT at lists.antique-tractor.com
>>> > http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>>>
>>> _______________________________________________
>>> AT mailing list
>>> AT at lists.antique-tractor.com
>>> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>>>
>>
>>
>> --
>> Howard
>> _______________________________________________
>> AT mailing list
>> AT at lists.antique-tractor.com
>> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>>
>
> _______________________________________________
> AT mailing listAT at lists.antique-tractor.comhttp://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>
>
> _______________________________________________
> AT mailing list
> AT at lists.antique-tractor.com
> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20210826/cd081fee/attachment.htm>


More information about the AT mailing list