[AT] 430V Freeze plug

[Phil Auten]

There's nothing like success to make your day! Congrats, Spencer.

Phil in TX


On 2/2/2020 11:01 AM, Spencer Yost wrote:
> So I started on the replacement of the leaking freeze plug last night.   Drained the radiator and the block.   The block was draining heavily rusted water the last few inches.   So getting that drained out was an unexpected plus.
>
> First I started with a small pilot hole in the freeze cup, then fitted a corse threaded screw to my dent puller(MAC tools “Slammer hammer”) and threaded the rig in.  I get two outcomes with this approach:  the plug either pops right out or it deforms badly enough that just a few taps with a hammer and chisel will begin to unseat it.  Then I can thread it in again and pull it out.  Here is a few pics.
>
> The culprit was a thin rusted out spot at the crease of the freeze cup. I’m glad I went ahead and took care of this.  I don’t think this freeze cup would have lastedthe next season.
>
> Hopefully I’ll get a chance to run by Napa and get a replacement today.
>
>
>
>
>
>
>
> Spencer Yost
>
>
> Sent from my iPhone
>
>
> _______________________________________________
> AT mailing list
> AT at lists.antique-tractor.com
> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20200203/1cc66fda/attachment.htm>