[AT] EDM

[Spencer Yost]

Dang !   That is amazing.

Ill bet they could figure out to cure 1/8” slop in the Pacer gear shift  that causes it to occasionally jump from the forks and lock me in two gears at the same time (-:

Actually, I dealt with this when I restored the tractor. I built it up through welding  as best I could but I think the forks are worn. I’m going to have to build up the end of the gearshift in an oblong pattern to keep it from jumping out.  

Spencer

Sent from my iPhone

> On Dec 9, 2019, at 4:10 PM, bradloomis at charter.net wrote:
> 
> 
> Since the topic has moved into casting and machining, I thought some might find this which I got in an email today of interest. What one can do with an EDM, discussed recently electrical discharge machining, is this little miracle
> https://www.instagram.com/p/B38yn5zBYwl/
> That is some fine tolerances!!
> Brad
> _______________________________________________
> AT mailing list
> AT at lists.antique-tractor.com
> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20191209/834ce481/attachment.htm>