[AT] 430V

[Indiana Robinson]

A quick tip on adjusting by the book... I learned some years ago to not
adjust the TA on my Super MTA and the 400 exactly by the book. It has been
a long time now and I would have to figure it out again. Basically you
adjust it by the book then continue to tweak it until it works right. You
need to remember on these old things that the factory wrote the book when
these tractors generally had zero wear on any of the various linkages.
After they get 50+ years of use/abuse on them you either have to replace
all parts to eliminate any slop or more practically you tweak "by the book"
to compensate for that wear. They never go back and rewrite the manuals
based on 50+ years of wear. Like on the TAs it may only be a few
thousandths but that is a few thousandths in maybe 8 places.
Throttle/governor linkages and internals can be a little the same way. I
have a VAC Case that has a "sort of" working governor. Its problems seem to
be mostly internal wear. I have another non-running VAC that I think has a
better governor but since this one "sort of" works and I am still trying to
catch up I just keep using the "sort of" one.  :-)  It pretty much just
pulls trailers.


.

On Tue, Dec 19, 2017 at 11:04 PM, Spencer Yost <yostsw at atis.net> wrote:

> Hey Dean,
>
> Not much is going on. It's been a busy holiday season. I did get the
> governor and throttle linkage adjusted according to the manual.   The
> governor linkage needed two more turns, but the throttle linkage was good.
> I got the new manifold gasket and carb gasket installed.  All of this made
> very minimal improvement. So the problem clearly needs to be in the
> carburetor.  The carburetor appears to be clean as a whistle, so I suspect
> the previous owner rebuilt it recently. It just simply must not have
> cleaned good enough.   That is next on my to do list, but I suspect I won't
> be able to even start until next week.
>
> The hay wagon likewise continues to languish :-(
>
> PS:  I probably should have suspected the carb from the beginning, as I
> have always felt like the adjustments on the carburetor did not react as I
> expected.   For example, the load adjustment needle basically does nothing.
> Likewise, the idle mixture screw makes very little difference.
>
> Spencer Yost
>
> > On Dec 17, 2017, at 12:42 AM, Dean VP <deanvp at att.net> wrote:
> >
> > Spencer,
> >
> > Haven't much lately about the 430V.  Any progress on the surging issue?
> >
> > Dean VP
> > Apache junction, AZ
> >
> >
> >
> >
> > ---
> > This email has been checked for viruses by Avast antivirus software.
> > https://www.avast.com/antivirus
> >
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>



-- 
-- 

Francis Robinson
aka "farmer"
Central Indiana USA
robinson46176 at gmail.com