[AT] Clutch Decision
charlie hill
charliehill at embarqmail.com
Thu Jul 29 12:16:59 PDT 2010
Mike I'm pretty much in your camp on this with one condition. If it were me
I would weigh the difficulty of separating the tractor again given what I
had to work with and if I had to pay someone to help me or do the work all
together. If I had the shop, tools and skills to do the work myself and if
the tractor wasn't about to get a nice paint job I'd put it back together
and do as you said. However, if I had to pay for help or didn't have a good
shop to work in or if the tractor was about to be painted and I didn't want
to mess up the paint job with another separation then I might go ahead and
replace it all now just in case.
Everything is relative.
Charlie
--------------------------------------------------
From: "Mike Sloane" <mikesloane at verizon.net>
Sent: Thursday, July 29, 2010 1:43 PM
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Subject: Re: [AT] Clutch Decision
> If it were me, I wouldn't replace anything. I would just remove the rust
> from the flywheel and pressure plate, clean up the disc, and put the
> whole thing back together. Slipping the clutch a little works wonders
> for polishing the components.
>
> Others may feel differently about this...
>
> Mike
>
> On 7/29/2010 1:10 PM, Ben Wagner wrote:
>> Hello,
>>
>> My 1945 Farmall A had a stuck clutch which turned out to be the pressure
>> plate rusted to the "driven member" clutch disk. There is no rust
>> pitting.
>>
>> What should I do? I was told that replacing the clutch is the best
>> option. However, the total will come to about $180. I don't mind
>> spending the money, but since the two halves separated without damage,
>> can I reuse the clutch? I also read that you can "slip" the clutch
>> slightly and burn off the old rust if you reinstall it.
>>
>> Could I clean the rust off the pressure plate and only buy the "driven
>> member" or even the other way around?
>>
>> And advice would be appreciated.
>>
>> Thanks,
>> Ben Wagner
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
More information about the AT
mailing list