[Farmall] Farmall H Electrical
Roger Showers
showersroger at yahoo.com
Wed Oct 15 03:59:34 PDT 2008
I agree with John if switch is off coil can not get hot when charger is on bat.cheak switch.Is it 6 or 12 volt ?
I--- On Tue, 10/14/08, E. John Puckett <ejpuckett at centurytel.net> wrote:
From: E. John Puckett <ejpuckett at centurytel.net>
Subject: Re: [Farmall] Farmall H Electrical
To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
Date: Tuesday, October 14, 2008, 8:30 PM
sounds like it is wired such that coil is powered all the time.
KEITH LIPSCOMB wrote:
> It was getting a spark before the wiring change because it was running.
However, the battery, although new, is not keeping up a charge. I've used a
charger to recharge the battery. The coil does get quite warm when I charge up
the battery with a charger.
> Keith
> ----- Original Message -----
> From: John Wilkens<mailto:jwilkens at eoni.com>
> To: Farmall/IHC mailing
list<mailto:farmall at lists.antique-tractor.com>
> Sent: Tuesday, October 14, 2008 12:13 PM
> Subject: Re: [Farmall] Farmall H Electrical
>
>
> Sorry, I thought you were Keith. John
>
> Breaker gap for coil ignition is .020" and for magneto ignition is
> .013". But your .016" gap should work.
> Are you getting any spark at the plugs? John
>
>
> At 03:46 AM 10/14/2008, you wrote:
> >MABE I AM WRONG I SET POINTS AT .16 ?
> >
> >--- On Mon, 10/13/08, John Wilkens
<jwilkens at eoni.com<mailto:jwilkens at eoni.com>> wrote:
> >
> >From: John Wilkens
<jwilkens at eoni.com<mailto:jwilkens at eoni.com>>
> >Subject: Re: [Farmall] Farmall H Electrical
> >To: "Farmall/IHC mailing list"
<farmall at lists.antique-tractor.com<mailto:farmall at lists.antique-tractor.com>>
> >Date: Monday, October 13, 2008, 8:47 PM
> >
> >OK, start to see if you are getting spark at one of the plugs. If
> >not, see if you are getting current to the coil (use a volt meter or
> >just see if it sparks at the terminal) with the ignition switch
> >on. If you have current to the coil take the distrib. cap off and
> >see if you can get a spark between the points (with the ignition
> >switch on) and check the points gap (about .20"). I assume you
> >didn't pull the distributor shaft out and didn't get it out
of
> >time? Sometimes a bad condenser can give problems with spark but if
> >it was running before that's probably not the problem.
Another
> >unlikely problem would be low conpression but probably not your
> >problem. Should be at least 60 lbs (minimal!) to run.
> >So, if you have in-time spark and compression about all that's
left
> >is fuel. That's easy to check with a squirt of starting fluid
into
> >the carb.....unless it is flooded :(.
> >My two cents worth. I probably forgot something obvious :). Let
> >us know what you finally determine. John W.
> >
> >
> >At 05:21 PM 10/13/2008, you wrote:
> > >It's a coil ignition.
> > > ----- Original Message -----
> > > From: John
Wilkens<mailto:jwilkens at eoni.com<mailto:jwilkens at eoni.com>>
> > > To: Farmall/IHC mailing
>
>list<mailto:farmall at lists.antique-tractor.com<mailto:farmall at lists.antique-tractor.com>>
> > > Sent: Monday, October 13, 2008 6:50 PM
> > > Subject: Re: [Farmall] Farmall H Electrical
> > >
> > >
> > > Magneto or coil ignition? John
> > >
> > >
> > > At 03:09 PM 10/13/2008, you wrote:
> > > >I've been rewiring my 1948 Farmall H and have run
into a
> > > >snag. After installing a new wiring harness, I
can't get the
> > > >tractor to start. The engine turns, but won't
start. In the
> >past
> > > >I've replaced the plugs, battery, and voltage
regulator...and
> >the
> > > >tractor started. However after this harness...it
won't start.
> >By
> > > >the way, I've polarized the generator and replaced
the ammeter.
> > > >
> > > >Any thoughts?
> > > >
> > > >Thanks.
> > > >
> > > >Keith
> > > >_______________________________________________
> > > >Farmall mailing list
> > > >http://www.antique-tractor.com/mailman/listinfo/farmall
> > >
> > >
> > > In the wide-open spaces of NE Oregon
> > >
> > >
> > > _______________________________________________
> > > Farmall mailing list
> > >
> >
>http://www.antique-tractor.com/mailman/listinfo/farmall<http://www<http://www/>.
> > antique-tractor.com/mailman/listinfo/farmall>
> > >_______________________________________________
> > >Farmall mailing list
> > >http://www.antique-tractor.com/mailman/listinfo/farmall
> >
> >
> > In the wide-open spaces of NE Oregon
> >
> >
> >_______________________________________________
> >Farmall mailing list
> >http://www.antique-tractor.com/mailman/listinfo/farmall
> >
> >
> >
> >
> >_______________________________________________
> >Farmall mailing list
> >http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
> In the wide-open spaces of NE Oregon
>
>
> _______________________________________________
> Farmall mailing list
>
http://www.antique-tractor.com/mailman/listinfo/farmall<http://www.antique-tractor.com/mailman/listinfo/farmall>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
>
>
--
John
another one of them
*.?-!.* cub owners
_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall
More information about the AT
mailing list