[AT] Neat jack idea

charlie hill chill8 at suddenlink.net
Mon Jan 14 05:21:10 PST 2008


Hi Hank,  I agree with you.  I think our definition of cribing is not the 
same.  I'm speaking in terms of the way a  house mover would crib up a house 
before putting the beams under it.  If you support it that way it won't 
matter which way or how it falls the cribing will catch it.  Jack stands are 
good on concrete but I've seen them bury down in dirt and turn over.  Again, 
that depends on the design of the jack stand.

Anyway we both believe in doing it the safe way.

Charlie
----- Original Message ----- 
From: <hank at millerfarm.com>
To: <at at lists.antique-tractor.com>
Sent: Sunday, January 13, 2008 9:40 PM
Subject: Re: [AT] Neat jack idea


>
> There are two safe ways to use any jack of any type.  The first is to
> know all possible ways the load could fall, and then physically place
> everyone (humans, cats, dogs, cows, ...) outside of that range.   The
> other, more practical way is to have good stable jack stands underthe
> load.   If the load will go very high you may have to jack up a
> little, put the stand in place, jack some more, add a second stand,
> then jack, then adjust the first stand, until you get things high
> enough.
>
> Your cribbing is fine for when the jack itself fails to hold the load,
> but the jack can tip.   Your stands have a base that will not tip
> (Make sure your stands really are stable.   A log can be a good stand,
> or it could be a bad one)
>
> If I never again lose a friend because the jack supporting his
> car/whatever fell over it will be all right with me.
>
> Jacks are for lifting, use solid stands once the load is lifted.
> This goes for any jack, not just the hi-lift type.
>
> The bottom line is think safety.  So use your brain.
>
> Quoting charlie hill <chill8 at suddenlink.net>:
>
>> I think the safe way to use those jacks (if the situation will allow) is 
>> to
>> have some cribing on hand.  Jack the load up 4 inches or so, insert a 
>> piece
>> of cribbing (cribing sp ?), go another 4 inches add another piece, etc.
>> That way if the jacks decides to auto-rachet down or turn over the load
>> can't fall very far.  Of course most of the time you would need it when
>> there was no cribing to be found.
>
>
>
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.516 / Virus Database: 269.19.2/1223 - Release Date: 1/13/2008 
> 8:23 PM
> 




More information about the AT mailing list