[AT] UpDate Old 955K traxcavator

[Clint D]

I decide to take the head to the head machine shop and have it 
manufluxed, had a crack running down the center thru all the Chambers, 
at the one leaking it was visable by eye.
So, for 1100.00 they are gonna fix it and completely rebuild the head 
including new injectors and chambers.

I thought that would be better than trying to chase down a used head and 
something wrong with it

Clint

toma wrote:
> Hi Clint,
>
> I am familiar with the D315 in the older Traxcavators and they indeed have 
> a precombustion chamber that screws in, it seals with a copper washer on 
> the bottom and an O ring at the top. There is a special tool available 
> from Cat for removing and installing. I am not sure if the D330 has the 
> same setup or if they are direct injection. Try a post on www.acmoc.org, 
> someone there will know for sure.
>
> Tom
>
> On Thu, 21 Jun 2007, Clint D wrote:
>
>   
>> I just put a rebuilt water pump on my D330T cat engine when It started
>> up, I am getting all kinds of water out from around an injector chamber.
>> of course water is getting in the cylinder as well.
>> My question, is it still necessary to pull the head and replace the
>> gaskets or is there some kind of seal around the inj. chamber, this is
>> the part that the actual injector goes in.
>> if I need to just remove it, is it just pressed in? and how would I go
>> about taking it out?
>> Clint
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>>
>>     
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>