[AT] Old 955K traxcavator

[JParks]

Clint
It sounds like you have a 955H 60A
yes, the precombustion chambers screw into the head, and have a rubber O
ring that seals them into the head casting.
The special tool looks like a splined bolt (splines instead of threads)
which fit into the chamber for removal and reinstallation.

>From your note, you implied by the water pump repair, that there may have
been a cooling problem.  Hopefully you detected this quickly and the head
was not cracked from overheating.

John Parks
Boise, ID


----- Original Message -----
From: "Clint D" <driggars at wildblue.net>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Thursday, June 21, 2007 12:20 PM
Subject: [AT] Old 955K traxcavator


> I just put a rebuilt water pump on my D330T cat engine when It started
> up, I am getting all kinds of water out from around an injector chamber.
> of course water is getting in the cylinder as well.
> My question, is it still necessary to pull the head and replace the
> gaskets or is there some kind of seal around the inj. chamber, this is
> the part that the actual injector goes in.
> if I need to just remove it, is it just pressed in? and how would I go
> about taking it out?
> Clint
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.472 / Virus Database: 269.9.2/858 - Release Date: 6/21/2007
1:46 PM
>
>