[AJD] Gaskets

[John Paur]

Most gaskets, excluding head and manifold gaskets are easily made and cost a
LOT less.  Get a roll of gasket material and with a ball pein hammer just
knock them out.  John

----- Original Message -----
From: "Robert M. Massengale" <ltcmikem at ktc.com>
To: "Antique John Deere mailinglist"
<antique-johndeere at lists.antique-tractor.com>
Sent: Tuesday, January 04, 2005 7:45 PM
Subject: [AJD] Gaskets


> I've run into a gasket problem that I suspect is not uncommon and am
looking for
> List suggestions.  When I removed the crankcase cover (B1841R) on my '41 B
(sn
> 109494) the gasket (B1842R) between this cover and the main case
disintegrated.
> At both my dealership and on jdparts.com the gasket part number B1842R
(PC-330,
> pg 64) comes back as "invalid part number".
>
> Is there a gasket source other than my dealership?  Do you just make your
own
> gaskets?  What about the "form a gasket" type material that comes in a
tube?
> Permatex?
>
> Any suggestions appreciated.
>
> Mike
> Robert M. Massengale
> Fredericksburg, Texas 78624
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>