[Ford-ferguson] 2N overhaul help

[Buckies at aol.com]

the sleeves should be put in the freezer, then they slip into the clean and  
prepped block.
but
first hold the sleeve upside down over the block to make sure the sleeve  
will protrude over the block, once installed, about 003 inch
install with an oak block fully prepared in advance, as you only have  5 
seconds after the freezer.
carefully remove the thin sleeves with a very dull screwdriver type thing.  
thick sleeves need a puller /driver
"thin sleeve" blocks can be honed to 083 over and use 083 pistons. Boring  to 
100 over is possible using v8 100 over race pistons. this will make your N  
real peppy. I have measured it at 34 hp. power camshaft is an option.
ron tepoel