[AT] now 3pt hitch
Herb Metz
metz-h.b at comcast.net
Mon Oct 30 06:37:09 PDT 2017
On the AC720 L&G tractor the pivot point for the 3pt anti-sway chains is
different than the pivot point for the two lower arms, causing the chains to
tighten/loosen as the implement goes up/down. Very undesireable, and can be
dangerous. I tried Dean's "Band-Aid" of adding washers; result was the
implement did not flop around when lowered,but the chains tightened when
raising the implement so that I could hardly get the implement clear of the
ground. And there is no easy way of relocating the pivot point to it's
proper location.
Result is I can not use AC720 for close cultivating in the garden. Maybe
this winter I can find time to reduce the significance of this undesireable
situation. Herb(GA)
-----Original Message-----
From: Dean VP
Sent: Sunday, October 29, 2017 11:22 PM
To: 'Antique tractor email discussion group'
Subject: Re: [AT] 430V update
I own a few Leinbach implements all the way out here on the opposite coast.
They have performed quite well and have no real complaints. I did have one
problem with their scoop. The three point pin spacing for the draft arms
were too narrow for my JD 750. Since the anti-sway chains on my JD750
attach to the inside of the draft arms, even with the absolute minimum chain
length, I couldn't keep the scoop from hitting the rear tires. .As a
Band-Aid I added at many washers to each mounting pin as I could to spread
the draft arms and that helped a whole bunch. I Haven't taken the time to
find out which, the tractor or the scoop, didn't meet the ASAE three point
specifications. At this late date is kind of a moot point
Dean VP
Snohomish, WA 98290
More information about the AT
mailing list