[AT] OT Cadillac Northstar engine

[charlie hill]

Cecil, around here you can buy nice Buick Park Avenues in the early 2000's 
for $2500 bucks or so.  They have rock solid 3.6 L V-6 push rod engines.
The problems with the early years intake plenums have been solved.  They
are hard to beat.

Charlie

-----Original Message----- 
From: Steve W. 
Sent: Friday, September 30, 2016 1:52 AM 
To: Antique tractor email discussion group 
Subject: Re: [AT] OT Cadillac Northstar engine 

Cecil Bearden wrote:
> I am sure some of you have some knowledge about the Northstar 4.6L 32V 
> engine.  My MIL dented in the entire passenger side of her 99 Deville 
> with 128000 miles.  I found a 989 for parts, but after inspection, it is 
> in better shape than hers and as 53000 less miles.   It is like new 
> inside and out.  However, it has the head gasket problem typical of 
> Northstar engines.  I would like to repair this car with the head bolt 
> kit made to solve the problem.  Has anyone done this?  A rebuilt engine 
> is $3600 shipping inc, or if I get the car to Pembquin ND, then they 
> will R&R the engine for the same price.
> Any advice.  Personally I do not like cars, but this one really felt 
> good to my old broken back!!
> 
> Cecil in OKla
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
> 


OOOH a death star....

Done a bunch of them. Have done the factory approved method and had them 
fail again. Have also used inserts with stock sized bolts.

Now I use the stud kit these folks sell. These work and hold real well.

http://www.northstarperformance.com/

It is possible to buy just the studs and make your own drill and tap 
guide if you want to save a couple hundred.

Oh, while you're in there, change the primary timing chain tensioner and 
the intermediate sprocket bushing. They tend to wear faster than the 
other pieces.

-- 
Steve W.
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at