[AT] Ford 2000 Diesel Three Point
Cecil Bearden
crbearden at copper.net
Wed Nov 2 05:52:40 PDT 2016
I am sure you have tried this, but I have seen the draft control
override the position control before. If yours has the little lever
under the seat, sometimes this get out of place.
Cecil in OKla
On 11/2/2016 1:32 AM, Ben Wagner wrote:
> It's been a little while since I've needed to enlist the power of ATIS to
> figure out a tractor problem, but I have one that stumps me tonight and I
> need to get the rig back to work.
>
>
>
> Working on a Ford 2000 diesel, US version of the Fordson Super Dexta.
>
>
>
> I am running short on ideas to figure out why the three point lift only
> lifts about 3 inches then stops. It will lift up the world three inches,
> but that's all it will do.
>
>
>
> I have changed the fluid, cleaned the screens, checked the relief valves,
> replaced every o ring. I checked the pump pressure, and it is good as a 50
> year old rig is going to be.
>
>
>
> I recreated the adjustments based off the I and T manual. Its all by the
> book.
>
>
>
> I am out of ideas. What would cause the three point arm to raise about
> three inches from ground level with full power but then stop?
>
>
>
> Ben W.
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
More information about the AT
mailing list