[AT] Ford 2000 Diesel Three Point

[Cecil Bearden]

I am sure you have tried this, but I have seen the draft control 
override the position control before.  If yours has the little lever 
under the seat, sometimes this get out of place.

Cecil in OKla


On 11/2/2016 1:32 AM, Ben Wagner wrote:
> It's been a little while since I've needed to enlist the power of ATIS to
> figure out a tractor problem, but I have one that stumps me tonight and I
> need to get the rig back to work.
>
>   
>
> Working on a Ford 2000 diesel, US version of the Fordson Super Dexta.
>
>   
>
> I am running short on ideas to figure out why the three point lift only
> lifts about 3 inches then stops.  It will lift up the world three inches,
> but that's all it will do.
>
>   
>
> I have changed the fluid, cleaned the screens, checked the relief valves,
> replaced every o ring.  I checked the pump pressure, and it is good as a 50
> year old rig is going to be.
>
>   
>
> I recreated the adjustments based off the I and T manual.  Its all by the
> book.
>
>   
>
> I am out of ideas.  What would cause the three point arm to raise about
> three inches from ground level with full power but then stop?
>
>   
>
> Ben W.
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at