[AT] Flat Belt Implements 101

[Ralph Goff]

On 10/2/2013 8:06 PM, charlie hill wrote:
> Al,  you asked for advise from those that have been there and done that so I
> won't
> comment on running it.  I'll just offer this.  If you go to Tractor Supply
> and look around
> you'll find some rolls of belting that is made for round balers.  It looks
> to me like it would
> run fine as belt pulley belting.  They should also have the splice kits to
> put it together.
> Check it out.  Maybe someone else will comment.
>
Charlie,it has to be an endless belt if you are running a crossed belt. 
Otherwise the splice or lacing will catch and wear as it crosses. If you 
can set up the tractor and pulley so it will run the right direction 
without crossing the belt, then you might be ok.
We run the saw that way, laced belt with no twist in it and it works 
fine. But for a hammer mill I think endless belting is the only way to go.

Ralph in Sask.
>