[AT] A little OT

[Dick Day]

Alan, I just checked Amazon and they do carry the 14" wheels.  There are
many different types. Is there one you would suggest for general purpose
use?

Thanks for the suggestion.

Dick


On Tue, May 21, 2013 at 10:34 PM, Alan Nadeau <ajnadeau1 at myfairpoint.net>wrote:

> I've spent quite a lot of time on one of those saws.   Sait makes good
> blades, as does Pferd.  A low cost brand that has been good in my use is
> Virginia Abrasives.  I don't know if Norton makes those blades in their
> "Norzon" line or not.  If they do they will be expensive but I know, from
> experience, that Norzon grinding discs will cut at roughly 3 times the
> stock
> removal rate and last twice as long doing it.
>
>
> ----- Original Message -----
> From: "Dick Day" <ddss at telebeep.com>
> To: "atis" <at at lists.antique-tractor.com>
> Sent: Tuesday, May 21, 2013 9:48 PM
> Subject: [AT] A little OT
>
>
> >I have not used a chop saw in years but I found myself in need of one
> >again.
> > I did some quick research and found that my local TSC carries the
> Kawasaki
> > (AllTrade) 14" chop saw for $99. The reviews were mostly 5 star.  I
> picked
> > one up, brought it home and was immediately disappointed. The only real
> > negative review I read was not about the saw, but the wheel that shipped
> > with the saw.  I ran into the same thing, the wheel cut great for the
> > first
> > 20 seconds and then it looks as if it became glazed and would cut no
> more.
> >
> > I am cutting cold steel 1/4" stock, not aluminum (I remember that using
> > some
> > wheels on aluminum can cause this).  I went back to TSC with the wheel
> and
> > they happily pulled a generic one from stock and sent me on my way.  It's
> > better than the one that came with the saw but think I'd like to get
> > something a little more aggressive.
> >
> > Arthritis has really taken a toll on me and I just cannot exert much
> force
> > anymore without hurting.
> >
> > Can anyone suggest a brand or type of wheel that I could get that would
> > allow me to cut a little faster? I am not as worried about a super smooth
> > cut as I am getting the material cut quickly.
> >
> > Thanks
> >
> > Dick Day
> >
> >
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
> >
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>