[AT] Moline Universal Tractor Manual.

[charlie hill]

Barry,  this might come in handy if you end up needing a kit for that carb.
It is a cross reference of most if not all M-S carbs and it shows what 
repair
kits fit each.  If you can't find a kit that says it's for your carb you may 
be
able to cross reference the kits you can find to your carb.   You may be 
able
to find one that has the parts you need in it.

http://www.carbkitsource.com/carbs/numbers/Marvel-Schebler/index.html

M-S carbs are finicky sometimes and very sensitive to being absolutely clean 
inside.
A small bit of dirt, trash or water down in the passages in the bottom of 
the carb bowl,
under the main jet will make it run very badly if at all.

good luck.

Charlie

-----Original Message----- 
From: joehardy at epix.net
Sent: Tuesday, March 19, 2013 9:46 PM
To: Antique tractor email discussion group
Subject: Re: [AT] Moline Universal Tractor Manual.

Hi Barry; What model Carb do you have? Following info is for models: TSX633, 
TSX650; TSX713; TSX714; TSX878. Recommended float setting is 1/4 inch when 
measured from nearest face of float to gasket on carb body.Suggested initial 
adjustment both low & high speed mixture adjustments needles is 1-3/4 to 2 
turns open from closed position. First, readjust high speed mixture needle 
for ok performance under load and engine is warm. Then readjust low speed 
mixture needle for slow speed operation. I have an I&T shop service manual 
for most MM tractors so if your carb is something different, let me know. 
I'm in process of rebuilding a MM335 for the past year and a half and my 
wife wants it out behind of our house ASAP. Spring is coming (I hope) in NE 
Pennsylvania so gotta get it running soon. Joe Hardisky  Ryman Farm Dallas, 
PA
----- Original Message -----
From: "Barry & Tanya Stait" <bst41474 at bigpond.net.au>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Tuesday, March 19, 2013 1:55:57 AM
Subject: [AT] Moline Universal Tractor Manual.

Hi all, just wondering if any would happen to have a copy of a owners manual 
or a repair manual for a Moline Universal tractor and would be able to copy 
and email the section on adjusting the carb to me.
My father has a Moline and I can not get it to idle.
Thank you. all in advance.
Barry Stait.
Barry & Tanya Stait.
Mudgee. NSW. Aust.
bst41474 at bigpond.net.au
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at