[AT] JD B Problems - An Update

charlie hill charliehill at embarqmail.com
Tue Aug 6 17:37:33 PDT 2013


Dean,  I agree with you about the hammer causing problems if you hit 
anything other than
the bolt on the puller.  However if the puller bolt is centered on the shaft 
a good hard shot
helps it along.  Of course I'm talking about in general use and not 
specifically on that JD.
I'll defer to your experience with them.

Charlie

-----Original Message----- 
From: Dean VP
Sent: Tuesday, August 06, 2013 7:59 PM
To: 'Antique tractor email discussion group'
Subject: Re: [AT] JD B Problems - An Update

Ralph,

The impact wrench is a good idea if the puller is strong enough. Some of the 
import stuff
won't handle that much torque/tension.  I have learned to grab the really 
old pullers at
swap meets that were made with better quality materials. In my limited 
experience it seems
to take a combination of a very tight puller and heat plus a little luck to 
get some of
these drive disks off.  The clutch can get pretty hot over its 50 year plus 
usage and then
the heating and cooling with possible storage outside in the elements can 
create a really
stuck assembly.  Patience is needed.  A bigger hammer may cause more 
problems than
solutions.  The worst one I've had took over a week of constant tension and 
daily heating
and cooling with an Acetylene Torch.  When it finally popped it sounded like 
a rifle shot.


Dean VP
Snohomish, WA

A gun is like a parachute. If you need one, and don't have one, you'll never 
need one
again.


-----Original Message-----
From: at-bounces at lists.antique-tractor.com 
[mailto:at-bounces at lists.antique-tractor.com]
On Behalf Of Ralph Goff
Sent: Tuesday, August 06, 2013 1:01 PM
To: Antique tractor email discussion group
Subject: Re: [AT] JD B Problems - An Update

On 8/6/2013 1:25 PM, charlie hill wrote:
> Sorry Dean,  I didn't see your message until I had sent mine.  At
> least we are both thinking about the same.
>
> Charlie
>
What about using an impact wrench on the puller? Carefully of course.

Ralph in Sask.
>

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at 




More information about the AT mailing list