[Farmall] Farmall Digest, Vol 106, Issue 2

[jtchall at nc.rr.com]

Thanks for the info. Finally decided the new needle valve was bad. Put the 
old one in and no leak. We're going to crank it up a few more times to see 
if it starts leaking. Since it was just dirty inside, there probably wasn't 
anything wrong the old one.

John Hall


-----Original Message----- 
From: James Bynum
Sent: Monday, April 08, 2013 7:26 PM
To: farmall at lists.antique-tractor.com
Subject: Re: [Farmall] Farmall Digest, Vol 106, Issue 2

Hi John,

Not sure if this helps but I got repair kit for my Zenith carburetor which
is for 61 and 161 series carburetors which was applicable to my Farmall
Super A.  The instructions indicate for this carb in order to obtain
correct fuel level check position of float to measure 1-5/32" plus or minus
3/64" from casting to farthest point of float.  Bend float arm next to
float to obtain measurement.  Do not bend float hinge.

However, I had issues with the old carb when trying to rebuild it (broke
something off inside carb body) and just decided to buy a new one from
Yesterday's Tractor Co. about 5 years ago.  The new one has worked great
since that time.

Hope this helps.

Good Luck,
Jim Bynum


On Sun, Apr 7, 2013 at 12:00 PM,
<farmall-request at lists.antique-tractor.com>wrote:

> Send Farmall mailing list submissions to
>         farmall at lists.antique-tractor.com
>
> To subscribe or unsubscribe via the World Wide Web, visit
>         http://www.antique-tractor.com/mailman/listinfo/farmall
> or, via email, send a message with subject or body 'help' to
>         farmall-request at lists.antique-tractor.com
>
> You can reach the person managing the list at
>         farmall-owner at lists.antique-tractor.com
>
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of Farmall digest..."
>
>
> Today's Topics:
>
>    1. Zenith float setting (jtchall at nc.rr.com)
>
>
> ----------------------------------------------------------------------
>
> Message: 1
> Date: Sat, 6 Apr 2013 17:44:35 -0400
> From: <jtchall at nc.rr.com>
> Subject: [Farmall] Zenith float setting
> To: "Antique tractor email discussion group"
>         <at at lists.antique-tractor.com>
> Cc: farmall <farmall at lists.antique-tractor.com>
> Message-ID: <5B3555472D4C4AABB210E69ADBFE74AC at office>
> Content-Type: text/plain;       charset="iso-8859-1"
>
> Anyone know the float height setting on a Zenith 12613A carb on a Farmall
> 100?
>
> Thanks,
> John Hall
>
>
> ------------------------------
>
> _______________________________________________
> Farmall mailing list
> Farmall at lists.antique-tractor.com
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
> End of Farmall Digest, Vol 106, Issue 2
> ***************************************
>
_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall