[AT] Ford 5000 Hydraulic lift cylinder
Cecil R Bearden
crbearden at copper.net
Wed May 2 05:07:57 PDT 2012
I might be able to make a tap or find one, then build up the broken part
with spray metal, then bore and tap it. I have done this with cast iron
before, but the spray metal powder is now as high as gold!!! I found a
complete top deck for $650, I think I will just chicken out and buy
it. I have about 70 acres of sweet clover that is needing cut and a
lot of other things that are pressing right now, and just do not have
the time. This was a tractor I was trying to sell....
Cecil in oKla
On 5/2/2012 5:55 AM, charlie hill wrote:
> Cecil, there is a place about an hour from here that rebuilds hydraulics
> for a living.
> That is all they do. I wonder if they would work on an oddball piece like
> yours
> and if there is a similar place anywhere near you?
>
> Charlie
>
> -----Original Message-----
> From: Steve W.
> Sent: Wednesday, May 02, 2012 5:45 AM
> To: Antique tractor email discussion group
> Subject: Re: [AT] Ford 5000 Hydraulic lift cylinder
>
> Cecil R Bearden wrote:
>> I would do that, but there is only 3/16 in. metal from the threads to
>> one side of the mounting boss. There is a control valve bore behind it
>> 1/2 in deep. It is an oddball thread, and the sleeve that threads into
>> it is expensive. There is not a lot of room to do much and the top of
>> the mounting boss must be within 0.010 of what is was before to work
>> right....
>>
>> Really just a very poor design. And these guys did not have Autocad to
>> blame the stupidity on!!!
>>
>> Cecil in Okla
>>
> Sounds like it would be a challenge. Could still be done though. I have
> welded up cylinder heads and blocks with similar tolerances.
> Not fun but it could be done. Probably best to use a TIG. Might need to
> cut the metal back then weld it up and machine it back, sort of the way
> you would do a crankshaft.
>
>
>
More information about the AT
mailing list