[AT] O.T. pipe size

[charlie hill]

Here you go.  go to this page: 
http://www.mcmaster.com/#stainless-steel-pipe-fittings/=iht4pc
look at this item number.  4347K352

That will be 1 1/2" sch. 10 pipe 3' long.   They might have it in black iron 
which would be cheaper but I didn't see it.

Charlie



-----Original Message----- 
From: Don Bowen
Sent: Friday, July 20, 2012 5:31 PM
To: Antique tractor email discussion group
Subject: [AT] O.T. pipe size

I need a section of pipe or tubing with an O.D. not greater than 2" with
an I.D. a little greater than 1 5/8".  This is for an Amateur Radio
tower.  The tubing between the antenna and rotator is 1 5/8". The peak
of the tower has a ring with a 2" I.D. and another about 2' down from
the peak.   A short piece of the unknown sized pipe/tubing will be
mounted between the rings and extending a little above the peak.  A
thrust bearing will be mounted at the top with the 1 5/8 passing through
and held by the bearing.

-- 
Don Bowen           KI6DIU
http://www.braingarage.com/Dons/Travels/journal/Journal.html

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at