[Farmall] Farmall H hydraulics

[Jerry Bossard]

Thanks Barney!



On Wed, Sep 28, 2011 at 3:37 PM, Barney Van De Weert <bbvande at yahoo.com>wrote:

> Jerry, there are 3 ports on the H pump, 2 are the same hooked together, one
> on the right and one on the left. They are a single acting system. When you
> pull the control lever back they are pressurized, you release it and they
> hold. Push it forward and it allows the oil to free flow back into the
> reservoir, the implement pushes the cylinder back to push the oil back to
> the reservoir. The 3rd outlet is a delayed circuit that would be used with a
> front and rear mounted cultivator or similar tool. It is the one on the left
> and I think is the rear one. The normal outlet would raise the front
> implement then the back would raise after that  by the 2n or delayed port.
>
> To do what you want to do you will need a valve connected to the pump port,
> could be as many spools as you want, and also need to route a return to the
> hydraulic unit usually the fill tube is used, I'd also add a filter after
> the valve on the low pressure side. You will also need to have the control
> lever on the tractor pulled and held back when you wanted to use the
> system.
>
> You should be able to find the parts you would need at most tractor supply
> stores, parts catalogs or Dealers. Don't forget possibly tractor junk yards
> as well as the Internet.
>
> Barney Van De Weert
>
>
> ________________________________
> From: Jerry Bossard <jerry.bossard at gmail.com>
> To: farmall at lists.antique-tractor.com
> Sent: Wednesday, September 28, 2011 12:28 PM
> Subject: [Farmall] Farmall H hydraulics
>
> Hello.
>
> Could someone point me in the direction of how I go about setting up the
> hydraulics on a Farmall H.  I'd like to add 3 point to the tractor, but I'm
> looking for information on which side is in and out on the tractor.  Also I
> was curious to know if I should use a monoblock control for up and down
> pressure.  I'm considering getting a two level system so I can run the 3
> point plus have aux hyd in the back for whatever may be attached to 3
> point.
> Feel free to point out certain brands or stores that would be best for
> getting these parts... I assume a Tractor Supply Store would work?
>
> Thanks,
>
> Jerry
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>