[Farmall] CUB Manual Misprint???

[Darrell Ratliff]

Pints is correct.  The gears are splash lubed and it only takes a small 
amount of fluid in the case.

From: szabelsk at gdls.com
Sent: Tuesday, July 05, 2011 10:34 AM
To: Farmall/IHC mailing list
Subject: [Farmall] CUB Manual Misprint???

I was working on the shifting forks on the Cub last weekend and decided it
would be a good time to drain and change the oil in the trans and rear
end. Drained everything by removing the plate on the rear end, since I
apparently don't have any drain plug anywhere (checked the manuals and
looked all over on both sides). After all was cleaned up and the plate was
back on. I pulled the fill plug and took a look at the manual to verify
the amount of oil to put in. According to the manual it 's 3.5 pints for
the trans, and 0.5 pt for the rear end. This sounded low so I grab a
different manual and it said the same thing. Is this a misprint that's
been carried through all the manuals?  Should that be quarts instead of
pints?

Carl Szabelski



This is an e-mail from General Dynamics Land Systems. It is for the intended 
recipient only and may contain confidential and privileged information.  No 
one else may read, print, store, copy, forward or act in reliance on it or 
its attachments.  If you are not the intended recipient, please return this 
message to the sender and delete the message and any attachments from your 
computer. Your cooperation is appreciated.

_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall