[Farmall] CUB Manual Misprint???

[szabelsk at gdls.com]

I was working on the shifting forks on the Cub last weekend and decided it 
would be a good time to drain and change the oil in the trans and rear 
end. Drained everything by removing the plate on the rear end, since I 
apparently don't have any drain plug anywhere (checked the manuals and 
looked all over on both sides). After all was cleaned up and the plate was 
back on. I pulled the fill plug and took a look at the manual to verify 
the amount of oil to put in. According to the manual it 's 3.5 pints for 
the trans, and 0.5 pt for the rear end. This sounded low so I grab a 
different manual and it said the same thing. Is this a misprint that's 
been carried through all the manuals?  Should that be quarts instead of 
pints?

Carl Szabelski



This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.