[Farmall] "H" oil filter questions

[Tim Savelle]

Pardon me for belaboring this thing, but I'm thinking ahead now....

1. Is it more time between oil changes or is it hours of actual use that
probably causes the gasket to harden to this degree?

2. If it's age, and I change the oil every few months. should I have to face
digging the gasket out each time I change the oil?

3. Thinking out of the box....is is possible to change out the entire oil
filter assembly and replace it with one that will accept a screw-on filter?
It has been pointed out that the oil filter in this tractor is a
partial-flow.  Can you get screw-on filters that are compatible with the oil
pressure and flow of a partial-flow system like this.

Thanks for the patience and help.

Tim


On Tue, Mar 9, 2010 at 12:09 AM, Kurt Musgrave <rvar at plainstel.com> wrote:

> Tim, the groove the gasket belongs in is below where you have the gasket
> sitting in the picture.  I think you will find that the old gasket is still
> it there, and it will be rock hard and will come out in little bitty chips.
> You'll need a tiny screwdriver or something, I have a pointed Craftsman awl
> that works perfect.  After you get the old gasket out the new one will fit
> very tight in the groove and likely you'll need a blunt object to push it
> down into the groove especially the last bit of it.
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>