[AT] Is everyone okay?

[John Wilkens]

Warren, best put in a new needle and seat while you're at 
it.   Sometimes when you solder a float it will weigh too much to 
work right.   Good luck.   John W.



At 09:04 AM 02/10/2009, you wrote:
>Seems like almost a month since a message from the atis list. It may reach
>72 degrees in upstate South Carolina today (it did yesterday). This time
>last week it was around 19 degrees.
>
>I've been splitting some wood with my Ford Jubilee and Unicorn log splitter.
>I think my carb float is leaking because it drips gasoline when not running.
>I soldered it once but either didn't get it emptied out or didn't get it
>sealed. I saw a replacement float at TSC and may go that route this time.
>After replacing the float I have to tinker with the needle setting as the
>tractor is running anemically. (No power under moderate load, i.e. starting
>out in road gear). Not good.
>
>Warren
>
>_______________________________________________
>AT mailing list
>http://www.antique-tractor.com/mailman/listinfo/at


                    In the wide-open spaces of NE Oregon