[AT] 3000 lift control valve adjustment questions
Cecil Bearden
crbearden at copper.net
Tue Sep 9 17:11:56 PDT 2008
If you cannot find anything that looks bent or warped, then I would use
the 2000 adjustments or find the specs for a 4000 and see if it is any
closer. I know this is not much help, but do we know for sure that this
tractor has not had a top deck broken sometime and replaced from a
salvage yard? Is there a serial number on the top deck??
Cecil in OKla
Don Bowen wrote:
> I have rebuilt the lift cover with new O-Rings and doing adjustments when I
> ran into a problem. If I do the draft control adjustment according to the
> shop manual for the 3000 the turnbuckle is about a quarter inch too short.
> Same when doing the position adjustment. If I use the procedure for the
> 2000 the turnbuckle adjustment is long enough but not by much. The tractor
> is an early production 3000 (April '65) according to the serial number and
> all casting dates support that.
>
>
>
> 3000 setup for Draft control adjustment
>
> Draft control lever in draft position.
>
> Quadrant 4 1/8 in. from top
>
> Shop manual shows 3.75 in. I tried both
>
> Lift arms in fully raised position
>
> Adjust plunger with turnbuckle to 0.200 in from face of casting
>
>
>
> 2000 Setup for Draft control adjustment
>
> Same as above except quadrant is 2 in and plunger is 0.144 from
> face of casting.
>
>
>
> Position control adjustment is the same for both except plunger distance is
> 0.144 on the 2000.
>
> Control lever in position control.
>
> Quadrant at full lowering position.
>
> Lift arms in fully lowered position.
>
> Adjust by changing length of position control rod.
>
>
>
> Any comments from the Ford crowd?
>
>
>
> Don Bowen KI6DIU
>
> http://www.braingarage.com/Dons/Travels/journal/Journal.html
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
More information about the AT
mailing list