[AT] Head gasket question

[John Wilkens]

Actually no John.  I have a good JD service manual but I guess I was 
too lazy to serch for that info.  Thanks for your response!   Hope to 
fire the old girl up in a day or two...or three.        John W.



At 01:51 PM 11/24/2008, you wrote:
>Deere Service Manual for the B says smooth surface of gasket to the 
>block side. You aren't attempting to rebuild the engine without a 
>service manual (or at least an I&T manual), are you?
>
>John Boehm
>Woodland, CA
>Visit my web site at http://vintagetractors.com
>
>
>
>
>--- On Mon, 11/24/08, John Wilkens <jwilkens at eoni.com> wrote:
>
> > From: John Wilkens <jwilkens at eoni.com>
> > Subject: [AT] Head gasket question
> > To: at at lists.antique-tractor.com
> > Date: Monday, November 24, 2008, 1:01 PM
> > OK, I stumped all the local experts again--not so hard to do
> >
> > lately!    Does it matter which way the gasket crimp
> > faces--toward
> > the block or toward the head?  (On a JD B)    There are no
> > clues on
> > the gasket and Fel-Pro is shut down for the holiday.
> > John W.
> >
> >                     In the wide-open spaces of NE Oregon
> >
> >
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
>_______________________________________________
>AT mailing list
>http://www.antique-tractor.com/mailman/listinfo/at


                    In the wide-open spaces of NE Oregon