[AT] OT Vulcanzing Rubber?

[William Powell]

It's a seat hinge. The piece is a stamped metal piece that has about a 1x1x1
square cube attached to it that is rounded on one end to fit a tube frame.
The rubber cube also has a small piece of pipe about 1" long and 3/8"
diameter. 

I have been able to make the stamped piece of metal (in rough form) but the
vulcanizing process is new to me.

Regards,

Will Powell  

-----Original Message-----
From: at-bounces at lists.antique-tractor.com
[mailto:at-bounces at lists.antique-tractor.com] On Behalf Of charlie hill
Sent: Wednesday, April 16, 2008 8:25 PM
To: Antique tractor email discussion group
Subject: Re: [AT] OT Vulcanzing Rubber?

Will, describe the part  or at least it's shape, how thick the rubber is and
if the rubber is a flat sheet or a shape.  Then maybe we can help.

Charlie
----- Original Message -----
From: "William Powell" <william.neff.powell at comcast.net>
To: "'Antique tractor email discussion group'" 
<at at lists.antique-tractor.com>
Sent: Tuesday, April 15, 2008 8:04 PM
Subject: [AT] OT Vulcanzing Rubber?


>
> Hello,
>
> Does anyone have experience vulcanizing rubber? I have a part I would like
> to make that has vulcanized rubber on it. The metal part I can make, the
> rubber part is a challenge... Would like to try to do it myself if 
> possible.
>
>
> Regards,
>
> Will Powell
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at 

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at