[Steam-engine] Gauge adjustment.

[Stacey Freeman]

Andy,
I might be wrong, but seems like Harold Starke can work on gauges too.

Stacey Freeman
Statesboro, Ga. 

-----Original Message-----
From: steam-engine-bounces at lists.stationary-engine.com
[mailto:steam-engine-bounces at lists.stationary-engine.com] On Behalf Of Andy
glines
Sent: Tuesday, November 14, 2006 1:12 PM
To: Steam
Subject: [Steam-engine] Gauge adjustment. 

I have a good 350 lb traction engine gauge.  The hand has been set to be
correct at 100psi.  While the gauge is correct at 100 it is off by quite a
bit at the bottom of the range.  There is about 15psi before the needle
moved off of the pin.  Who should I contact about adjusting the gauge so
that is is more accurate at lowere pressure?

Andy Glines
Evansville, IN


 
____________________________________________________________________________
________
Do you Yahoo!?
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com
_______________________________________________
Steam-engine mailing list
http://www.stationary-engine.com/mailman/listinfo/steam-engine