[AT] 8n hub

[Chris Britton]

One thing to think about.. hubs only cost about 50 bucks..

Also.. once the hub bottoms.. it it is below the contact are o fthe nut.. it 
won't do much good.. washer would have to be cut so as to avoid the splines 
to apply pressure on the hub.

Soundguy

>From: "Cecil Bearden" <crbearden at copper.net>
>I should have noted that the 8N had the tapered splined axle.  I think we
>fixed those by machininf off some of the hub so that it would go up farther
>on the axle splines.  Then washered up under the nut.