[AJD] Special tool needed?

[Jim Showers]

I got them from Snap-on...aint cheap
Jim Showers
----- Original Message ----- 
From: "Bus Driver" <mpmbd at yadtel.net>
To: "Antique John Deere mailing list" 
<antique-johndeere at lists.antique-tractor.com>
Sent: Sunday, October 09, 2005 8:40 PM
Subject: Re: [AJD] Special tool needed?


> General Motors used clutch head screws for some purposes back in the early
> 50's.
> ----- Original Message ----- 
> From: "Chris C" <jdnutinwa at yahoo.com>
> To: "ATIS LIST" <antique-johndeere at lists.antique-tractor.com>
> Sent: Sunday, October 09, 2005 12:51 PM
> Subject: [AJD] Special tool needed?
>
>
>> I feel stupid asking this,  I should know and allready
>> have one...
>>
>>    I have been fighting to remove some of the 'clutch
>> head' bolts from an A,  you know, they are shaped like
>> the phillips head bolts that hold the sheet metal on,
>> specifically the grills to the front end,  but have
>> the oval shaped slot instead of the phillips head..  I
>> can't even remember what I used to use,  I know I
>> can't find whatever it is,  and my tool supplier looks
>> at me like I am nuts when I try and order something.
>>
>>     The best thing I have found is a large caburetor
>> butterfly scredriver that will work on ones that are
>> already loose..  I would like something that could go
>> on the end of a 1/4" or 3/8" ratchet.
>>
>>      Any help greatly appreciated!
>>
>>             Chris
>>
>>
>>
>> __________________________________
>> Yahoo! Music Unlimited
>> Access over 1 million songs. Try it free.
>> http://music.yahoo.com/unlimited/
>> _______________________________________________
>> Antique-johndeere mailing list
>> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
>