[AJD] Special tool needed?

[Bus Driver]

General Motors used clutch head screws for some purposes back in the early
50's.
----- Original Message ----- 
From: "Chris C" <jdnutinwa at yahoo.com>
To: "ATIS LIST" <antique-johndeere at lists.antique-tractor.com>
Sent: Sunday, October 09, 2005 12:51 PM
Subject: [AJD] Special tool needed?


> I feel stupid asking this,  I should know and allready
> have one...
>
>    I have been fighting to remove some of the 'clutch
> head' bolts from an A,  you know, they are shaped like
> the phillips head bolts that hold the sheet metal on,
> specifically the grills to the front end,  but have
> the oval shaped slot instead of the phillips head..  I
> can't even remember what I used to use,  I know I
> can't find whatever it is,  and my tool supplier looks
> at me like I am nuts when I try and order something.
>
>     The best thing I have found is a large caburetor
> butterfly scredriver that will work on ones that are
> already loose..  I would like something that could go
> on the end of a 1/4" or 3/8" ratchet.
>
>      Any help greatly appreciated!
>
>             Chris
>
>
>
> __________________________________
> Yahoo! Music Unlimited
> Access over 1 million songs. Try it free.
> http://music.yahoo.com/unlimited/
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere