[Steam-engine] boiler feedwater injector conection

[Jim Showers]

Keep in mind the fact that an injector inlet MUST be below water level for 
the injector to work.
Jim Showers

----- Original Message ----- 
From: "Richard Strobel" <Richard_Strobel7 at msn.com>
To: "Steam-engine mailing list" <steam-engine at lists.stationary-engine.com>
Sent: Tuesday, November 08, 2005 8:10 AM
Subject: Re: [Steam-engine] boiler feedwater injector conection


>
>
>
>>
>> As far as a feed water line into the vertical boiler under discussion, I 
>> would not run it into the bottom as it would stir up the sludge as water 
>> is put in. I would run it into the top of the boiler,
>
>
> Blake see below..how would I install a pipe inside a boiler?
>
>
>
> but I would put a pipe inside the boiler to a point well
>> below the water level, but not too close to the tube sheet.
>
>
> Thanx
> RickinMt.
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine
>