[AJD] 530 Reassembly Questions
Kenneth Jones
kenejons61 at yahoo.com
Sun Mar 6 16:35:09 PST 2005
John
Thanks for your assistance. I did set the end play per specifications but the gear doesn't seem to turn independently. Looks like I am going to need to take that shaft out and determine wher the problem exists..Have been using the 60, 720 and the I & T 530 service manual but will dig out my B manual for further reference points..
Thanks so much
Ken Jones
JDNut at aol.com wrote:
In a message dated 3/4/05 6:29:12 PM, kenejons61 at yahoo.com writes:
<< In putting my 530 back together, I have several questions where I could
use your assistance:
Should the counter shaft idler gear be able to turn independently of the
remainder of the gears on the counter shaft? I have installed the counter
shaft and the sliding gear shaft but no where in my reference materials do I find
that the double idler gear should turn independently of the other gears on
that shaft once the nut on the left side of the shaft is tightened.
>>
Kenneth,
I hope you have gotten some good advice directly, and not via the list. But,
in case you hadn't, my initial reply is that yes, that the B 3607R idler gear
does run independent of the other gears on the shaft. Are you sure the
bearing has been pressed on far enough? Also, I don't know how much it would
affect what you are seeing, but there is a critical end play adjustment with spaces
on the right side. I have found the SM 2004 service manual for the styled
"B" tractors to be helpful for many of the Waterloo tractors. It has a lot more
detail than the later service manuals. If you are still stuck, and I can
help, let me know.
John Maxwell
_______________________________________________
Antique-johndeere mailing list
http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
---------------------------------
Celebrate Yahoo!'s 10th Birthday!
Yahoo! Netrospective: 100 Moments of the Web
More information about the AT
mailing list