Fw: [Ford-ferguson] Dearborn plow 10-156
David Bruce
davidbruce at yadtel.net
Sat Jan 8 19:03:11 PST 2005
Thanks for the info - right now I'm trying to get the rust frozen nuts
loose that adjust the beam. It seems they have never been adjusted (or
at least not in a LONG time and are rusted up pretty tight. I'm not
looking for perfection - just a plow that will track more or less in the
proper line - perfection can come after that so this will give me a
great starting point. Thanks again.
David
rdlotze at juno.com wrote:
>
> David
> I didn't see anyone answer you so here goes:
> First I didn't find 10-156 in my plow book so I can't be specific.
> In general find a nice level spot with the plow on tractor - cement pad
> would be nice - place an 8" block under both of the left wheels -
> assuming you plan on plowing 8" deep - lower the plow to ground and
> center plow left and right so both stop chains on the lift links are
> equal - level plow with leveling box on tractor so plow sets level left
> to right - measure from inside of right tire to a line along the right
> plow land side surface - this should be the same as the size of the plow
> (12" - 14" - 16") also distance from beam to beam - make adjustment to
> plow to get this - The wheels should be near or at narrowest setting -
> sight plow beams along length of tractor - they should be parallel - if
> not adjust plow to get it parallel - this may require readjust land side
> to tire - top link adjustment should hold plow so that only the tips of
> the points touch the ground and the rear ends of the land sides should be
> off the ground 1" to 2" - adjust top link to get this.
> This will get you started and final adjustment can be made after trying
> in the field - Note using or not using coulters will make a difference in
> settings - coulter should cut at least 4" down and 1" to left of each
> plow
> Dick
>
> --------- Forwarded message ----------
> From: David Bruce
>
> I've had this plow for several years, I got it with a Massey 35 in a
> combo deal (along with a Massey bushhog type mower, a roll over type box
> scrape and a yard tool. Previously I haven't done much with the plow
> but I am trying to round it into shape and maybe plow my garden. Last
> time I tried to use it, it would not run true so I thinking I should
> adjust it on the beam that connects to the lift arms. Can anyone give
> me some advice or point me in a proper direction to find some. BTW the
> shins, shares and moldboards seem to be in good shape - just need a bit
> of scouring. I've also got the coulters but normally around here
> coulters aren't used (NW NC). Thanks in advance.
>
> David
>
>
> _______________________________________________
> Ford-ferguson mailing list
> http://www.antique-tractor.com/mailman/listinfo/ford-ferguson
>
>
> _______________________________________________
> Ford-ferguson mailing list
> http://www.antique-tractor.com/mailman/listinfo/ford-ferguson
>
More information about the AT
mailing list