[AJD] Final Drive Drain Plug

[Robert M. Massengale]

Thanks Ron.  That's probably going to be the best route.  Unless I 
get another suggestion that will work today, I'll pick up an adapter at 
NAPA when I go to town tomorrow.

Mike
Robert M. Massengale
Fredericksburg, Texas 78624

> I think you are about right, Mike.  I am not sure what I used in the
> past, but how about a 1/2 to 3/4 adapter for your socket driver?  If
> it is a 3/4 square, that should work.
> 
> Ron Cook
> Salix, IA
> 
> Robert M. Massengale wrote:
> > Almost embarrassing to ask...  I though I had the transmission &
> > final drive in my '41 B drained, but just discovered the large drain
> > plug for the final drive under the drawbar support.  Unlike the
> > transmission pipe drain plug, the final drive drain plug has a
> > recessed square slot.  I don't have any tools around the shop that
> > fit the drain plug hole. The square end on my 1/2 inch scoket
> > extension is too small.  It looks to be about a 3/4 square recessed
> > hole in the drain plug.  Is there a common tool Im overlooking that
> > fits this hole or am I going to have to fire up the forge?
> > 
> > Mike
> > Robert M. Massengale
> > Fredericksburg, Texas 78624
> > _______________________________________________
> > Antique-johndeere mailing list
> > http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> > 
> > 
> 
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 
>