[Steam-engine] Repro Castings

[Harold Kuret]

If the castings are fairly simple ( no cores required) you simply need to
fill any holes in the castings.

I usually use drywall compound or poly filler.

Harold Kuret
Lynden, Ont. Canada


----- Original Message ----- 
From: "Andy glines" <pioneersop96 at yahoo.com>
To: "Steam" <steam-engine at lists.stationary-engine.com>
Sent: Tuesday, February 15, 2005 3:30 PM
Subject: [Steam-engine] Repro Castings


> I am gathering a few pieces that I need to have
> reproduced in order to complete the restoration on the
> huber.  For now, I intend to use original castings as
> patterns.  How do I need to prepare these castings
> before shipping them to the foundry?
>
> =====
> Andy Glines
> Evansville, IN
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - You care about security. So do we.
> http://promotions.yahoo.com/new_mail
> _______________________________________________
> Steam-engine mailing list
> http://www.stationary-engine.com/mailman/listinfo/steam-engine