[AJD] Tap Extractor

[Chris C]

Dee,

   No you are with it,  I am just fuzzy..  I just want
to pick up a new tap extrator,  and the JD tool that
was designed for the job just to have it.  This is
about the 10th carb I have gone through this year, 
guess I should not answer the phone when I am working
in the garage.  Fortunately I did not break the
casting of the carb body.  My needs for the above
mentioned tools have nothing to do with completing
this carb,  I just want them.  

          Chris

--- Dee Schuyler <web22hsz at verizon.net> wrote:

> Chris.
> Either it is late or I am just not with it tonight,
> probably a good guess!
> But if the nozzle is out , what is the tap broke off
> in? I usually run a tap 
> up inside the nozzle
> then use a long bolt with several washers and nuts
> to pull the nozzle out of 
> the  carb body.
> I have a very old set of carb tools one of them is a
> tapered left handed 
> thread slide hammer puller. However I have found it
> almost worthless on old 
> carbs and use a little heat and the little threaded
> puller I spoke of 
> earlier.
> Good luck Take your time .
> Dee
> ----- Original Message ----- 
> From: "Chris C" <jdnutinwa at yahoo.com>
> To: "ATIS LIST"
> <antique-johndeere at lists.antique-tractor.com>
> Sent: Thursday, December 22, 2005 6:50 PM
> Subject: [AJD] Tap Extractor
> 
> 
> >
> >
> >    I was on a roll last night.  I bought a DLTX-19
> > for my AR on Ebay,  the guy didn't describe it
> very
> > well,  said it was a DLTX-10 but clearly wasn't, 
> so I
> > bought it for what I thought was a grat price.
> >
> >     I was tapping the brass nozzle to pull it out
> > when the phone rang..  Set the carb on the bech..
> get
> > phone.. carb falls to floor,  breaks tap on inside
> > nozzle..
> >
> >     I used to own a tap extractor,  but alas it
> could
> > not be found.  Three parts stores and one hardware
> > store later,  everyone knew what i wanted,  nobody
> had
> > it..  I did manage to get the nozzle out,  it is
> > destroyed now however.  The rest of the carb is
> great,
> > all the passage ways are clear..  Much better than
> > the carb that came with the tractor.. It looked
> like a
> > ball of mud,  inside and out.
> >
> >      Anyone have an extra nozzle tool that Deere
> used
> > to sell for removing these nozzles?
> >
> >                   Chris
> >
> >
> >
> > __________________________________________
> > Yahoo! DSL - Something to write home about.
> > Just $16.99/mo. or less.
> > dsl.yahoo.com
> >
> > _______________________________________________
> > Antique-johndeere mailing list
> >
>
http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> > 
> 
> 
> _______________________________________________
> Antique-johndeere mailing list
>
http://www.antique-tractor.com/mailman/listinfo/antique-johndeere
> 



		
__________________________________________ 
Yahoo! DSL – Something to write home about. 
Just $16.99/mo. or less. 
dsl.yahoo.com