[Farmall] Hello

[E. John Puckett]

Stan, I was raised on H tractors.  The handle that loaded the engine but didn't 
do anything was probably the hydraulic (Liftall) control.  It would have been a 
rod on the right extending back toward the driver, a little over knee high.  If 
the outlets were plugged pulling it would have caused the pump to run against 
the relief valve, and with the engine idling made a noticeable load.

Stan Bass wrote:
> The H was also
> an early model (remember it had the 1-1/8" PTO) that we knew very little
> about. Back then we didn't even know that 3 pnt kits existed. We used it
> with all pull type implements. I remember getting curious one day and
> just trying every knob or handle I could find to see what it did. Knew
> about the PTO, found the belt pulley, and some other handle that would
> load the engine hard but I couldn't see anything move? Asked my Dad and
> brother later, stumped them too!
> Stan(VA).

> 

-- 
John
another one of them
*.?-!.* cub owners