[AT] Finally done

[Matthew]

Re: snap coupler

I have an AC and it seems to be a bit different, or it might have been
modified before I got it.

The main pulling part is way under the tractor, and you have to back the
implament over it, being careful to be perfectly centered up.  Then you
need to get down there and lift the thing up and get it into the hole and
put a pin through to hold it.  The two bottom plow I have is quite heavy
and it takes two people and a big stick as a lever to push the tongue up
or if I am by myself I will use my hydraulic car jack to lift it up.
Then there are two arms on the top that go to the arms that come off of
the lift pistons.  Again, you need to futz with moving the arms and the
implament to get it all lined up and pinned.  I have never found anything
to effect the height of the implament except the main lift/lower lever.

You can see pictures at http://badpoodle.org/tractors and you can get a 
pretty good look at the main part of the hitch in this picture:

http://badpoodle.org/tractors/big/DSCN3631.JPG

Am I missing pieces or was the hitch way different between the CA and the
WD?

--Matthew