[AT] Small Zenith carb (CA) question please
John Wilkens
jwilkens at eoni.com
Tue Jun 29 17:56:12 PDT 2004
Thanks Grant! I will look into the problem area you mention. I never
thought of that. I did check the float and level. No problem there. John
At 01:37 PM 06/29/2004, you wrote:
>Hi John,
>
> I've found that the gasket surfaces on those old Zeniths tend to warp,
> especially on the top section. This warpage will not allow the gasket to
> seat properly and gas will suck into the venturi area from the float bowl
> when the engine is running. File the gasket surfaces down flat or sand
> them flat with some emery glued down to a table. The gasket is rather
> thin in the area around the venturi and is subject to leakage. Also,
> sometimes the venturi will hold up the top of the carb lid section
> causing the gasket to not seal. Bottom line is that sometimes Zeniths
> are hard to seal around the venturi, and that you have to watch this area
> or gas will suck in. Hope this helps!
>
>Grant Weir
>Saskatoon, SK.
>Canada
>
>
>
>>From: John Wilkens <jwilkens at eoni.com>
>>Reply-To: Antique tractor email discussion group
>><at at lists.antique-tractor.com>
>>To: at at lists.antique-tractor.com
>>Subject: [AT] Small Zenith carb (CA) question please
>>Date: Tue, 29 Jun 2004 11:30:01 -0700
>>
>>The CA is running rich--blowing black smoke. I put two sizes smaller
>>main jet in (.24) and set the float level a little lower (float valve is
>>not leaking) and it still smokes and fouls plugs. Then I put a
>>Zenith carb from a Wisconsin engine on it (same size main jet) and it
>>runs fine--no black smoke--but the linkage is all wrong for use on the
>>CA.
>>So.........does anyone have a clue as to what might be wrong with the
>>original carb?? Could someone have drilled some passage way out inside
>>and messed it up?? If you know of a small carb expert I might contact
>>with this question please let me know. John Wilkens
>>
>> In the wide-open spaces of NE Oregon
>>
>>
>>
>>_______________________________________________
>>AT mailing list
>>http://www.antique-tractor.com/mailman/listinfo/at
>
>_________________________________________________________________
>Tired of spam? Get advanced junk mail protection with MSN Premium
>http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines
>
>_______________________________________________
>AT mailing list
>http://www.antique-tractor.com/mailman/listinfo/at
In the wide-open spaces of NE Oregon
More information about the AT
mailing list