[AT] 560 steering ?

[Edward Tabor]

Kevin,
    Can a good hydraulic shop rebuild the worn front pieces.  Seems like 
to me, not a whole lot could really wear out there, so perhaps it may be 
nothing more than some seal replacements and a helluva good clean out. 
 (Of course I'm not overly sure of the actual set up here.  I f not, 
perhaps they could suggest an alternative route to go.  

Ed

Irma wrote:

> 
>
> 
>
> I have a Farmall 560 that I could be using now, if only I could steer it. 
>Steering locked up while raking hay yesterday. This is the second time
>fixing this, last time was  about 55 hours back.
>
>Then the IH dealer could`nt get parts, they were N/A.
>
>This tractor uses a recirculating ball guide that runs on a worm shaft. 
>That is where the problem is again. Only now I can not find anything at the
>yards. But what I would really like  to find is a front chunk manual
>steering. If any of yall know anywhere i could find this.  Or how about
>going back to the wide front, and rigging up a rack & pinion setup ???  
>
>
>
>Any info on this will be appreciated
>
>Thanks
>
>Kevin
>
>Mosier 
>
>
>
> 
>_______________________________________________
>AT mailing list
>http://www.antique-tractor.com/mailman/listinfo/at
>
>
>  
>