[AJD] Drat.

[Duane Larson]

Eric,
I think Dengler sells clutch drivers with oversized splines - might they
work with yours?  I also have the name of a shop that rewelds them and
resplines - I'll look around and see if I can find it.
Regards,
Duane Larson

----- Original Message ----- 
From: "Eric LaCruze" <ericlacruze at comcast.net>
To: "Antique John Deere mailing list"
<antique-johndeere at lists.antique-tractor.com>
Sent: Thursday, December 30, 2004 11:16 PM
Subject: [AJD] Drat.


> I need a crank, or repair for clutch splines, on my Styled AO crank.
> I came into a very nice 60 crank, with journals and bearings. It doesn't
> fit. The main journals are bigger, and the journals from the later
> tractor are oiled through the maincase rather than plumbed directly from
> the pump like the AO.
> Sooo...
> The clutch side would work with only replumbing the line and making the
> appropriate hole in the maincase. The flywheel side has a boss around
> the journal housing which leaves about a 1/2" gap between the maincase
> and housing where the oil port is. I could place a fitting in the
> journal and plumb the line through a hole in the case...
>
> Or I could trade off the very nice 60 crank and journals for a nice A
> crank or repair to mine.
>
> Any ideas?
>
> Eric
> _______________________________________________
> Antique-johndeere mailing list
> http://www.antique-tractor.com/mailman/listinfo/antique-johndeere