[AT] Wire size for welder?? Help welder people!

[Dean VP]

Grant:

I totally agree and it is supported scientifically.

Dean A. Van Peursem
Snohomish, WA 98290

I'm a walking storeroom of facts..... I've just lost the key to the
storeroom door 


www.deerelegacy.com

http://members.cox.net/classicweb/email.htm



-----Original Message-----
From: at-bounces at lists.antique-tractor.com
[mailto:at-bounces at lists.antique-tractor.com] On Behalf Of Grant Brians
Sent: Wednesday, December 08, 2004 8:42 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Wire size for welder?? Help welder people!

I would run 6 gauge. Why? Because 10 gauge is what I run for 120V 20Amp
circuits. Honestly, all of my welder circuits are either 4 or 6 gauge
depending on the length and they NEVER get warm. This is not scientific, but
I tried a very long run at 6 gauge once and found I could not get the full
welder output. So I am sticking with one size up in wire size from the
charts and it always works safely and efficiently.
        Grant Brians
        Hollister Calfornia
----- Original Message ----- 
From: "John Wilkens" <jwilkens at eoni.com>
To: <at at lists.antique-tractor.com>
Sent: Tuesday, December 07, 2004 8:01 PM
Subject: [AT] Wire size for welder?? Help welder people!


> If I have a 230 volt mig welder that is rated at 45 amps input current I
> assume I would want a 50 amp 230 volt breaker .  But what minimum romex
> wire gauge would I need to run 25' from the breaker box to the outlet box
> for the welder?   For years I've used 10 gauge wire for my 225 amp output
> Lincoln buzz box.     John W.
>
>                     In the wide-open spaces of NE Oregon
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at