<div dir="ltr">I've run miles of copper at two wineries for air and nitrogen, glycol, and water. In the last few years I've used ProPress fittings, but that is a bit pricey for a one off home shop. Although our pressures are regulated to about 110 for air and 100 for nitrogen there are no leaks and PP is good for 350 if I recall. Heck PVC is good for that. Higher if you go Sch. 80. I know a few shops that are run in PVC. It doesn't get any easier than that, if you support it well so it doesn't look like a sagging old mess. I would never do pipe. Way too much work. I may be cheaper in the long run, but PU, without a machine I wouldn't even think of that. I wouldn't now and I have access to one. :) We also use a lot of nylon tubing for smaller runs, and to connect rams, etc. with push to connect fittings. McMaster. That also takes fairly high pressures, not sure the max w/o looking it up. <div>Brad</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Fri, Sep 10, 2021 at 6:43 PM Spencer Yost <<a href="mailto:spencer@rdfarms.com">spencer@rdfarms.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">So I’m going to be making three new pipe runs from my air compressor.  Previously I’ve just relied on hoses since the 50 foot hose will reach everywhere in my shop.<br>
<br>
It will consist of one long “trunk” run that will be nearly 40 feet, and then a few stub runs of anywhere from 5’ to 15’ <br>
<br>
I was thinking about black pipe as that’s what I have used before. But I had no idea the common, affordable black pipe you find in hardware stores is only good to 150 psi. My compressor is two stage and is 175 psi:<br>
<br>
3/4-in x 3-ft 150-PSI Black Iron Pipe <a href="https://www.lowes.com/pd/Southland-Pipe-3-4-in-x-3-ft-150-PSI-Black-Iron-Pipe/3371442" rel="noreferrer" target="_blank">https://www.lowes.com/pd/Southland-Pipe-3-4-in-x-3-ft-150-PSI-Black-Iron-Pipe/3371442</a><br>
<br>
I guess I’m thinking about biting the bullet and going copper. I’d like to go with some of those really neat new aluminum systems but I could never afford that.<br>
<br>
What are y’all think about copper? I know 3/4” copper is good to about 1000 psi.   It eliminates  the rust problem that eventually befalls all black steel pipe systems; which is kind of a plus.  As far as installation, I solder better than I cut threads :-)<br>
<br>
<br>
<br>
Spencer<br>
<br>
<br>
Sent from my iPhone<br>
_______________________________________________<br>
AT mailing list<br>
<a href="mailto:AT@lists.antique-tractor.com" target="_blank">AT@lists.antique-tractor.com</a><br>
<a href="http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com" rel="noreferrer" target="_blank">http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com</a><br>
</blockquote></div>