<div dir="ltr">Thanks for the update, Spencer!  Glad to hear the picks worked as intended!<div><br></div><div>SO</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sat, May 22, 2021 at 11:36 AM Spencer Yost <<a href="mailto:spencer@rdfarms.com" target="_blank">spencer@rdfarms.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Finally had a chance to work on the clip today and the picks are definitely the way to go. Just a few minutes later and I had the clip out. Just some very light tabs with a hammer and I got the straight pick behind the clip enough to pry it away from the groove almost an 1/8”.  I then could get another pick in too that would push further out and lift at the same time.<br>
<br>
 The pick that I thought would be useful actually wasn’t .   The offset one was used to lift the clip up and away.   I thought the 90° one would work the best but it just was too hard to get it keep its’ shoulder anchored all the while holding another pick with another hand.  <br>
<br>
<br>
<br>
_______________________________________________<br>
AT mailing list<br>
<a href="mailto:AT@lists.antique-tractor.com" target="_blank">AT@lists.antique-tractor.com</a><br>
<a href="http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com" rel="noreferrer" target="_blank">http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com</a><br>
</blockquote></div>