<div dir="ltr">I've had spotty luck with tap extractors.  Down around 1/4-20 and under, they can be too flimsy if the tap is jammed (it broke, didn't it?).  And you're screwed, pun intended, with spiral-flute taps.  But they can work, with a little luck and patience.  I have also had some luck with "heat & beat" (using a center punch to break the tap into smaller pieces which, you hope, can be worked out individually)<div><br><div>Brad, if your stainless jobs are giving you trouble, it's probably due to the tendency for stainless to work-harden.  It can be mitigated with adjustment to speeds & feeds, and certain cutting fluids and certain tap coatings (if not carbide) are more appropriate for stainless.</div><div><br></div><div>Steve O.</div></div></div>