[AT] 12,000 lb winches

[jahaze at aol.com]

I'll try to respond, although most times my e-mail doesn't get through.  I have a Ramsey 12,000lb cable winch on my trailer, and I do not sit on the tractor when loading as I feel it's much safer to be on the ground at the back of the trailer.
I think a rope winch would be great, if you can keep them dry, I worry about deterioration of the rope over time (which may not actually be an issue?).  I try to stay away from the cheaper brands, although since it gets used very little right now, it's an expensive paper weight.
Enjoy, Joe


Sent from the all new AOL app for iOS


On Thursday, April 18, 2024, 1:41 AM, Dean VP <deanvp at att.net> wrote:

 Since my accident I am unable to turn my head to the rear nearly as much as I was able to in the past which wasn't all that good before as I've gotten older.  But,,,,  I still want to load tractors on my 20' tilt 10,400 lb GVW equipment trailer but in a little safer way than before.  I tend to load tractors on backwards so I can get more weight on the tongue since JD Two Cylinder tractors have about 70% of their total weight on the rear axle. My heaviest Two Cylinder is a JD 720 LP Standard which weighs close to 8000 lbs. So... my idea is to get a 12,000 lb Winch mounted to the very front of the tilt bed and winch tractors on rather than back them on. My thinking is to have a cordless remote so I could sit in the seat of the tractor while it is being pulled on so I could steer a bit if necessary.  I do have removable fenders and the bed is 102" wide through the whole 20' except between the tires so I don't have to be perfectly centered.  Now thinking of Winches i have decided that even though my heaviest tractor is 8000 lbs I will be pulling up a slope so I need the extra pulling capacity and I want the extra capacity to get a better duty cycle.  If one looks at the specs of various winches Duty Cycle is not even mentioned or conveniently hidden but if one digs deep enough you will find worrying specs of winching 45 seconds under full load and then have to wait 15 minutes.  That is not compatible with my needs.  Especially when typical winching speeds of 20 FPM are applied to a 20'trailer.  Initial looks at some higher priced winches gets better Duty Cycles that appear to be acceptable. Then the winch specs are based on which level the tow cable or rope is at which gets really confusing. I am leaning toward getting a rope as opposed to a steel cable just simply because how nasty steel cables can be. If necessary, I'm willing to replace the rope occasionally if it wears out. I'm thinking of using a steel plate that has a right angle that wraps around the front end of the bed frame bolted in and then bolt the winch and plate though the bed. I haven't found a commercial plate that does that so may have to fabricate one. But given all those parameters, I am interested in what ATIS members have found to work for them. Or whatever brands are suggested for Winches and recommendations on how to mount the winch on the bed of the trailer.  I don't want to spend more than necessary but I also realize I can't lowball this. .Any comments, suggestions and help will be appreciated. 


  
  _______________________________________________
AT mailing list
AT at lists.antique-tractor.com
http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20240418/fb9f1f54/attachment.htm>